1. Welcome to the official forum for MINIX devices!
    Dismiss Notice

No stand-by after FW008 update

Discussion in 'Official Firmwares' started by Serban13, Jun 8, 2018.

  1. Serban13

    Serban13 New Member

    The system doesn't go into complete stand-by after this update. The LED stays on blue light and the USB ports are powered. Because I use an external HDD I want to use stand-by and have the USB ports disabled. Is there any way to change this?

    Thank you very much.
     
  2. MINIX - Martin

    MINIX - Martin Moderator Moderator

    I tried to replicate your problem.
    Here's what I get from the test which lasts half an hour.
    Sleep the U9-H with IR remote or power button on the device for a couple of time when my cell phone connects to the device.
    Sometimes the blue LED light turn to green quickly and the cell phone cannot charge anymore.
    Sometimes I have to wait for 1 minute before the blue LED light turns green, and then the cell phone does not charge anymore.
    So, you may as well leave HDD attached on the U9-H for 1 or 2 minutes after you sleep the U9-H.
    I think it will work.
     
  3. Serban13

    Serban13 New Member

    Thank you so much for your answer. I have also tested some more and it is true, sometimes it takes just a bit longer for the system to enter standby mode.

    It usualy works just fine, so I guess that it was just an Android bug imediately after the update.

    Thank you again.
     
  4. MINIX - Martin

    MINIX - Martin Moderator Moderator

    Might be a little bug, but I think it does not matter that much.;)